Zutaur It was not possible to unsubscribe — please try again later eb contact the Danish Standard Please make sure you are logged in. Are you sure you want to unsubscribe? Are you sure you want to unsubscribe monitoring? Du abonnerer allerede dette emne. You may find similar items within these categories by selecting from the choices below:.
|Published (Last):||2 June 2018|
|PDF File Size:||18.55 Mb|
|ePub File Size:||19.96 Mb|
|Price:||Free* [*Free Regsitration Required]|
In accordance with Adobe s licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe s licensing policy.
Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO s member body in the country of the requester.
The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee.
International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. This second edition cancels and replaces the first edition ISO , of which it constitutes a technical revision.
A complete listing of these bodies can be found at www. For this reason, the solid wire electrode, solid strip electrode, solid wire or solid rod may be classified on the basis of any of the above product forms and can be used as appropriate, for more than one of the above processes.
The classification of the solid wire electrodes, solid strip electrodes, solid wires and solid rods is based on their chemical composition. For dated references, only the edition cited applies.
For undated references, the latest edition of the referenced document including any amendments applies. ISO , Welding consumables — Technical delivery conditions for filler materials and fluxes — Type of product, dimensions, tolerances and markings ISO , Welding consumables — Procurement of filler materials and fluxes ISO , Quantities and units — Part 1:General 3 Classification The classification is divided into two parts: a the first part indicates the product form, being solid wire electrode, solid strip electrode, solid wire or solid rod, see 4.
NOTE One product form can be used for more than one welding process. The following four digits indicate the chemical composition of the solid wire electrode, solid strip electrode, solid wire or solid rod, determined under conditions given in Clause 6. The remaining digits indicate the alloy composition of the welding consumable.
A description of common uses of each welding consumable alloy is given in Annex A. The basis of the system of designation is described in Annex B. NOTE In addition, the chemical symbol can be used.
DIN EN ISO 18274:2006-05
UNE-EN ISO 18274:2011