A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. Scope 1.
|Published (Last):||27 September 2006|
|PDF File Size:||7.18 Mb|
|ePub File Size:||15.89 Mb|
|Price:||Free* [*Free Regsitration Required]|
Unless otherwise specified see 5. B Either Brinell or Rockwell B hardness is permissible. C Bend test not required for steels thicker than 1 in. D Material 0. E Maximum.
Type is usually used in the heat-treated condition quenched and tempered to a specified range of hardness or tensile strength. F Rockwell C scale. ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years and if not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phone , fax , or service astm.
More A It includes rounds, squares, and hexagons, and hot-rolled or extruded shapes, such as angles, tees, and channels in the more commonly used types of stainless steels. The bars shall be furnished in one of the following conditions: Condition A in which the bars are annealed, Condition H in which the bars are hardened and tempered at a relative temperature, Condition T in which the bars are hardened and tempered at a relatively high temperature, Condition S in which the bars are strain hardened or relatively light cold worked, and Condition B in which the bars are relatively severe cold worked. The material shall be subjected to a mechanical test to determine its tensile strength, yield strength, elongation, and Brinell hardness. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Unless otherwise specified see 5. B Either Brinell or Rockwell B hardness is permissible. C Bend test not required for steels thicker than 1 in. D Material 0. E Maximum. Type is usually used in the heat-treated condition quenched and tempered to a specified range of hardness or tensile strength. F Rockwell C scale.